Hello all,
I have a Fluke 199C Scopemeter. I went to use it the other day, plugged it in since I didn't know if it was charged or not. I powered it on. The scope came on for about 5 minutes and I haven't been able to turn it in since. The power pak is 17.8 volts. I measured about 21 volts with no load. The voltage goes to the 17.8 range when plugged into the scope. The battery is fully charged at about 8.35 volts. Supposed to be 7.2 volts. The battery gets very hot when charger is plugged in. You can handle it, but its quite warm. Does anyone have any suggestions or ideas?
Thanks
Jack
I have a Fluke 199C Scopemeter. I went to use it the other day, plugged it in since I didn't know if it was charged or not. I powered it on. The scope came on for about 5 minutes and I haven't been able to turn it in since. The power pak is 17.8 volts. I measured about 21 volts with no load. The voltage goes to the 17.8 range when plugged into the scope. The battery is fully charged at about 8.35 volts. Supposed to be 7.2 volts. The battery gets very hot when charger is plugged in. You can handle it, but its quite warm. Does anyone have any suggestions or ideas?
Thanks
Jack