Tektronix tds2012...let say i don't want to remove the ground..and as per my friend advise use the 1:1 transformer between measurement....do you think it'll work? tHanks a lot.
Hello Guys....just wondering why the power is tripping when i probe osciloscope to measure clock signal output from PWM IC (uc3525)...Thanks in advance.
Thanks for the reply...yes you're right about "triggered" --something like the temp exceeds as normal...
Can you please name the ic so i can search it in google and also the microcontroller...Sorry im new in electronics...thanks.
Hello Guys…I am making a sensor design using 6 pairs thermocouple as a thermal sensor around the machine. I want the output goes like this…if only 1 over 6 thermocouples triggered a yellow led lit. And if more than 1 thermocouples triggered then a red led lit…Thanks a lot for sharing your ideas…
I am troubleshooting a power supply...i found a PWM IC UC3846...any idea how to confirm that PWM IC or any type of PWM IC is working by onboard by voltage reading? I measured Vcc is ok (15Vdc) and Vref read 5Vdc. Please help...i am in new and enjoying this electronic world. Thank u guys...
Now i'm getting confuse :-(
Please help get a conclusion...since i measured it fuse-open and looks like smd inductor...do i need to replace it?
Just to add up..this mosfet source pin is connected to ground. Thanks.
Hello i am new on this forum....i am troubleshooting an intrument...i found a mosfet with inductor (label L3) connects at drain and source...when i check the inductor it is fuse-open (read in Mohms). Wondering if it is really an inductor or not...because it is not normal to me to see inductor at...