A
[email protected]
- Jan 1, 1970
- 0
i have a pyrometer (thermocouple and an analog gauge)...the setup take
a fairly long time to settle at its final temperature, and i'd like a
much faster response rate..
i was thinking that if whatever was reading the thermocouple analyzed
the RATE of change of the temperature, it could figure out what the
FINAL temperature would be..the time constant is a predictable thing,
right?
i.e. it sees where the current reading is on the exponential
"settling" curve and can therefore predict where it will end up
is this possible? is this done?
a fairly long time to settle at its final temperature, and i'd like a
much faster response rate..
i was thinking that if whatever was reading the thermocouple analyzed
the RATE of change of the temperature, it could figure out what the
FINAL temperature would be..the time constant is a predictable thing,
right?
i.e. it sees where the current reading is on the exponential
"settling" curve and can therefore predict where it will end up
is this possible? is this done?