B
Ben Bradley
- Jan 1, 1970
- 0
I have a cheap digital camera, Medion MD-6136, that I want to power
externally, and I need the power connector. According to the manual
the connector is 0.75mm OD and 0.35mm ID. And yes, the receptacle in
the camera does look to be about that size, it's MUCH smaller than the
dozens of "standard" size power connectors. I looked in Digikey and
Mouser catalogs and didn't see anything that small. Does anyone have
any idea where I can get just one or two of these connectors,
especially for a reasonable cost? Is there a wall-wart DC power supply
(manual gives specs of 3.3 to 3.5VDC, 2.5A) made for the camera with
this connector?
I just found this:
http://support.medionusa.com/kb/dis...706&categoryid=8&productid=50007380&retailer=
This link doesn't say, but the PDF manual says it needs DC with the
negative on the outside.
externally, and I need the power connector. According to the manual
the connector is 0.75mm OD and 0.35mm ID. And yes, the receptacle in
the camera does look to be about that size, it's MUCH smaller than the
dozens of "standard" size power connectors. I looked in Digikey and
Mouser catalogs and didn't see anything that small. Does anyone have
any idea where I can get just one or two of these connectors,
especially for a reasonable cost? Is there a wall-wart DC power supply
(manual gives specs of 3.3 to 3.5VDC, 2.5A) made for the camera with
this connector?
I just found this:
http://support.medionusa.com/kb/dis...706&categoryid=8&productid=50007380&retailer=
This link doesn't say, but the PDF manual says it needs DC with the
negative on the outside.
