Static convergence on Thomson 52RG75J?

[Dan Payne]

Hello group,

Anyone know how to adjust the static convergence on a Thomson 52RG75J (ICC9
chassis)?
Dynamic convergence is done with pots under the front facade, but I think
static convergence is normally done using a service mode in the remote
control. Is this correct?
I don't have an original remote control, so can't enter the service menu
(on orig. menu and + buttons simultaneously). Is there any key sequence that
can be used on a universal remote control to enter the service mode?

thanks
Dan

 

[Art]

Static is normally relating to mechanical adjustments such as centering,
width, height, etc. Dynamic on all relatively new chasis is always done via
a technician setup menu.

 

[Dan Payne]

Thanks, but the generalities I know already. I'm looking for the specifics
on this one. It's an old design rear screen projector, with potentiometers
for the dynamic convergence, and I can see on the schematic that the static
convergence levels (centering etc) are set by a DAC chip on the I2C bus.
Therfore I assume that setting is done by the remote control.
Dan