R
Reg
- Jan 1, 1970
- 0
Have a simple Piezo in a helmholz housing.
Would like to make a huge amount of noise with it but...
I only have a three volt battery supply, and would like to deviate from the
resonant frequency a bit - to be a bit more creative than just square wave
warbling.
I have seen the following arrangements:
1) A choke (say 10mH) in series with a diode and the both in parallel with
the Piezo, then one junction (Piezo and choke) to an NPN and the other
(Piezo and diode) to +V
2) An NPN to the centre tap of a 10:1 transformer in a 'T' arrangement with
the outer connections to either end of the Piezo then where the 'primary'
joins the Piezo to +V
3) An NPN to the centre tap of a 10:1 transformer in a 'T' arrangement but
one end goes to the Piezo which is connected to 0v and the other end is
connected to +V
Can anybody enlighten me as to the advantages/disadvantages of such
different configurations and what is the most efficient way to get 50+ volts
p-p into the Piezo?
Obviously there will be a resonant frequency but if I can get sufficient
voltage the 'off resonant' won't matter much.
Are there better ways to drive them i.e half/full bridge.
Component cost is not really an issue, but volume is.
Thanks for any advice.
Cheers
Reg
Would like to make a huge amount of noise with it but...
I only have a three volt battery supply, and would like to deviate from the
resonant frequency a bit - to be a bit more creative than just square wave
warbling.
I have seen the following arrangements:
1) A choke (say 10mH) in series with a diode and the both in parallel with
the Piezo, then one junction (Piezo and choke) to an NPN and the other
(Piezo and diode) to +V
2) An NPN to the centre tap of a 10:1 transformer in a 'T' arrangement with
the outer connections to either end of the Piezo then where the 'primary'
joins the Piezo to +V
3) An NPN to the centre tap of a 10:1 transformer in a 'T' arrangement but
one end goes to the Piezo which is connected to 0v and the other end is
connected to +V
Can anybody enlighten me as to the advantages/disadvantages of such
different configurations and what is the most efficient way to get 50+ volts
p-p into the Piezo?
Obviously there will be a resonant frequency but if I can get sufficient
voltage the 'off resonant' won't matter much.
Are there better ways to drive them i.e half/full bridge.
Component cost is not really an issue, but volume is.
Thanks for any advice.
Cheers
Reg