T
thepcbdude
- Jan 1, 1970
- 0
I am doing a quick survey on PCB schematic / layout tools used. If you
have a couple minutes could you answer the following questions and
email me at [email protected]. I will post the results of the
survey.
1) What schematic capture tool do you use?
2) What PCB layout tool do you use?
3a) Do you use these tools for Analog design?
3b) Digital design?
3c) RF design?
4) Are you a hobbyist or a professional?
5) If a professional, how large a company do you work for ( number of
employees
a:1-9, b:10-99, c:100-999, d:1000+?
6) how many boards do you do a year?
7) Which of the following best describes the complexity of your typical
board ?
a: very simple - 1 or 2 layers, no high density parts/routing,
no advanced features.
b: simple - 4 or less layers, no high density parts/routing, no
advanced features.
c: moderate - 4 or more layers, uses high density parts/routing
or some advanced features.
d: complex - 4 or more layers, uses high density parts/routing
and multiple advanced features.
8) What Country, State/Province are you located in?
have a couple minutes could you answer the following questions and
email me at [email protected]. I will post the results of the
survey.
1) What schematic capture tool do you use?
2) What PCB layout tool do you use?
3a) Do you use these tools for Analog design?
3b) Digital design?
3c) RF design?
4) Are you a hobbyist or a professional?
5) If a professional, how large a company do you work for ( number of
employees
a:1-9, b:10-99, c:100-999, d:1000+?
6) how many boards do you do a year?
7) Which of the following best describes the complexity of your typical
board ?
a: very simple - 1 or 2 layers, no high density parts/routing,
no advanced features.
b: simple - 4 or less layers, no high density parts/routing, no
advanced features.
c: moderate - 4 or more layers, uses high density parts/routing
or some advanced features.
d: complex - 4 or more layers, uses high density parts/routing
and multiple advanced features.
8) What Country, State/Province are you located in?
