Optima XM6 alarm problem

[Marky]

I have a problem with my alarm

I had a power cut last night and it seems to have rendered the syste
unresponsive.
I'm getting a power on light but no response from key pad or any othe
light.
The power light goes out when I take out the spur fuse so I assume tha
the back up battery is dead. I can replace that but what about the no
responsive keypa

 

[Sam Goldwasser]

I have a problem with my alarm

I had a power cut last night and it seems to have rendered the system
unresponsive.
I'm getting a power on light but no response from key pad or any other
light.
The power light goes out when I take out the spur fuse so I assume that
the back up battery is dead. I can replace that but what about the non
responsive keypad

First try removing the backup battery AND power entirely for a couple
minutes. It may just be in a strange state.

--- sam | Sci.Electronics.Repair FAQ Mirror: http://repairfaq.ece.drexel.edu/
Repair | Main Table of Contents: http://repairfaq.ece.drexel.edu/REPAIR/
+Lasers | Sam's Laser FAQ: http://repairfaq.ece.drexel.edu/sam/lasersam.htm
| Mirror Sites: http://repairfaq.ece.drexel.edu/REPAIR/F_mirror.html

Note: These links are hopefully temporary until we can sort out the excessive
traffic on Repairfaq.org.

Important: Anything sent to the email address in the message header above is
ignored unless my full name is included in the subject line. Or, you can
contact me via the Feedback Form in the FAQs.

 

[Travis Jordan]

The power light goes out when I take out the spur fuse so I assume
that the back up battery is dead. I can replace that but what about
the non responsive keypad

Replace the backup battery with the power off, then restore mains.

The alarm may come up in the default 'alarm' mode - if so and your code
doesn't work, the default factory preset code is 0123.