Dave,I messed with it again last night and i noticed a click about 2
sec. after i turned it on. So, it might be going into safe mode
but, i still haven't seen any error code. I bought the receiver like
this. I figured it was something minor but ,i m not a tech either.
I didn't pay that much for it so i can put alittle into it . Suggested
retail for this receiver is $1599.00
I'd start from square one. Get out the owner's manual,
http://63.148.251.135/redirect_service.cfm?type=own_manuals&file=TX-S...
Disconnect all the wires. Hook up your speakers as shown in the manual. Go
into setup and test the speaker levels. Or you can use the microphone that
comes with the unit and plug it into the jack in the front of the receiver
and it will automatically set the levels. Again, see the manual for
instructions on this. If you can make it past this point, then hook up a dvd
player AND either a coax or optical digital cable between the receiver and
dvd player. Go back into the setup menu (remove the microphone) and make the
appropriate settings to the audio select input menu. Please report your
findings.
Good luck.
--
David Farber
David Farber's Service Center
L.A., CA- Hide quoted text -
- Show quoted text -