C
Craig
- Jan 1, 1970
- 0
I have a project, I am trying to convert the X/Y/Z (blank) signals from a
circuit designed to output to a vector scan monitor and redirect them to
laser either by galvanometer/PC interface/anything possible to active this..
Can you help direct me to resources or the best way to do this?
This is for a single laser output (one color).
The problem also is that I want to increase the axis range dynamically so
that I can project on a wall, building, anything....
Thanks for any helpful suggestions!
Anyone for hire to help do this???
-Craig
[email protected]
circuit designed to output to a vector scan monitor and redirect them to
laser either by galvanometer/PC interface/anything possible to active this..
Can you help direct me to resources or the best way to do this?
This is for a single laser output (one color).
The problem also is that I want to increase the axis range dynamically so
that I can project on a wall, building, anything....
Thanks for any helpful suggestions!
Anyone for hire to help do this???
-Craig
[email protected]