J
Joseph
- Jan 1, 1970
- 0
I'd like to build a metal detecting induction proximity sensor. Something
that can pick up a stainless disk (size of a dime) at .2 inch. Flipping
through the Allied catalog I see page after page of cylindrical (M18)
induction sensors.
Is there a common technique "everyone" is using that I should look into?
Can someone give me some circuit details to point me in the right direction?
thx
that can pick up a stainless disk (size of a dime) at .2 inch. Flipping
through the Allied catalog I see page after page of cylindrical (M18)
induction sensors.
Is there a common technique "everyone" is using that I should look into?
Can someone give me some circuit details to point me in the right direction?
thx