Connect with us

Designing FPGA project with Altium instead of Vendor Tool

Discussion in 'General Electronics Discussion' started by snoop911, Sep 28, 2010.

Scroll to continue with content
  1. snoop911

    snoop911

    3
    0
    Nov 30, 2009
    I'm thinking of using Altium to target an Actel SmartFusion FPGA (has hard arm ip!!). Normally the vendor tool, libero in this case, would probably synthesize/route the best logic, but I'd really like to utilize some of Altium's IP blocks... including the Tasking Processor for some multiprocessor fun!

    Anyone have any experience using Altium to do FPGA design?

    Any issues switching back and forth between Altum and the vendor tool to tweak and/or program the chip?
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-