Hi guys, I don't have much knowledge about electronics so I got kinda confused in a few things in this project I'm working on.
ok so the project is a phono stage I'm making for my turntable. It's a project found here: http://www.tnt-audio.com/clinica/solidphono_e.html
I uploaded the schematics of the PSU and Phono preamp that were given.
anyway I would like to know what would be the right way to connect the electrolytic capacitors because it is not shown in the schematics (the symbols are like of film capacitors).
Also, I'm a bit confused with the 0v shown in the PSU schematic, as there are only two voltage cables coming out from the toroidal transformer (well, two for each channel). do I need to connect anything there? should there be a connection between the two different boards grounding (the project is made of two different units- each in it's own enclosure)
ok so the project is a phono stage I'm making for my turntable. It's a project found here: http://www.tnt-audio.com/clinica/solidphono_e.html
I uploaded the schematics of the PSU and Phono preamp that were given.
anyway I would like to know what would be the right way to connect the electrolytic capacitors because it is not shown in the schematics (the symbols are like of film capacitors).
Also, I'm a bit confused with the 0v shown in the PSU schematic, as there are only two voltage cables coming out from the toroidal transformer (well, two for each channel). do I need to connect anything there? should there be a connection between the two different boards grounding (the project is made of two different units- each in it's own enclosure)