Does anybody have any tips for building circuits on Veroboard?
I've been using LochMaster to try and design my circuit. I've selected my veroboard and then sized it accordingly using the software.
All my components physically fit onto the board but when I come to arranging them so everything is connected correctly I run out of room. I suspect it is something I'm doing wrong though I can't see what can go wrong, its just a case of using the strips and interconnecting them with jumpers but maybe there are a few techniques I'm not aware of.
I could of course simply use a bigger board but I rather not if I can help it as its final installation - within an enclosure - is limited in space.
EDIT: Yes I'm aware I've missed an L in the title but I can't edit it now
I've been using LochMaster to try and design my circuit. I've selected my veroboard and then sized it accordingly using the software.
All my components physically fit onto the board but when I come to arranging them so everything is connected correctly I run out of room. I suspect it is something I'm doing wrong though I can't see what can go wrong, its just a case of using the strips and interconnecting them with jumpers but maybe there are a few techniques I'm not aware of.
I could of course simply use a bigger board but I rather not if I can help it as its final installation - within an enclosure - is limited in space.
EDIT: Yes I'm aware I've missed an L in the title but I can't edit it now