I
Ingo
- Jan 1, 1970
- 0
Dear all,
I'm currently working on a interconnect model using resistances,
internal and mutual inductances. For the simulation of frequency
effects, my approach uses simplified skineffect formulas, which of
course take f into account for the calculation. Is there any chance to
get the frequency used by LTSpice during simulation (e.g. using the .AC
command). SwitcherCADIII so far only gives me a warning that it can't
use the frequency using (freq or w).
Any suggestions?
Best regards,
Ingo
I'm currently working on a interconnect model using resistances,
internal and mutual inductances. For the simulation of frequency
effects, my approach uses simplified skineffect formulas, which of
course take f into account for the calculation. Is there any chance to
get the frequency used by LTSpice during simulation (e.g. using the .AC
command). SwitcherCADIII so far only gives me a warning that it can't
use the frequency using (freq or w).
Any suggestions?
Best regards,
Ingo