-
Categories
-
Platforms
-
Content
Search results
-
Reduce the effect of C as well as the Parameterization
Hello fellow Electronites, I'll just dive straight in. Here's a picture of a circuit I'm simulating. 1ST ENQUIRY : So the blue line has a bounce (caused by the internal capacity of the conductivity sensor which is represented here by R7 & C2 ) that I'd like to eliminate. Any ideas? 2ND...- z0d
- Thread
- Replies: 2
- Forum: General Electronics Discussion
-
How to get Cs and Rs?
Hello, I'd like to know how to get Cs and Rs.. Here I've substituted arbitrary values for both Rs And Cs; only R1 is set at 100Ω[ I varied this from 10Ω - 150Ω ] . So from ltspice I got an output like this But if I hook this circuit up to an osci [with Cs and Rs unknown] I get this. Any...- z0d
- Thread
- Replies: 5
- Forum: General Electronics Discussion
-
Programmable Resistor suggestions?
Hello world, I'd like to create a sensor circuit say for either temp/pressure/conductivity [OR ALL THREE, SEPARATELY OFC] that incorporates a wheatstone bridge. In it, I'd like to have a programmable resistor that'll auto-compensate ( no manual adjustments necessary ) the changes in Rsensor...- z0d
- Thread
- Replies: 5
- Forum: General Electronics Discussion
-
Selection of Op Amps
Hello, I'd like to get some perspective in this area. 2 main enquiries. 1st being, in a Relaxation Oscillator Circuit, what are the parameters of the Op Amp that define the output voltage? [eg. slew rate, GBW, R-to-R] So say for example I have a ±5V supply [not V- or V+] for the OpAmp and I'd...- z0d
- Thread
- Replies: 6
- Forum: General Electronics Discussion
