-
Categories
-
Platforms
-
Content
Search results
-
F
Analog to Digital Signal Block Diagram Confirmation
Good day to all, Please i need your Support in helping me to confirm if the block diagram i attached to this thread is correct. I want to read an analog Signal from a sensor and convert it to a digital Signal with the help of an in-built ADC in a microcontroller. I am not sure if the...- firstoption
- Thread
- Replies: 3
- Forum: General Electronics Discussion
-
F
Applying a Sensor Output Analog voltage to a microcontroller
Thank you very much for the Response. I am very grateful . You are perfectly i saw the detail Information in the section you directed me to.Once again thank you for the Support.Best regards.- firstoption
- Post #7
- Forum: Sensors and Actuators
-
F
Applying a Sensor Output Analog voltage to a microcontroller
Thank you all for taking the time to respond to my question . I really appreciate your sense of understanding. I was unable to upload the file because of the size but below is a link to the datasheet...- firstoption
- Post #4
- Forum: Sensors and Actuators
-
F
Applying a Sensor Output Analog voltage to a microcontroller
Good day to all, Please I need help on how to get a stable 5V to my microcontroller. I want to convert the Output analog Signal from a sensor to digital Signal using the ADC peripheral in a microncontroller.According to the datasheet of the sensor,the Output voltage analog Signal has a...- firstoption
- Thread
- Replies: 6
- Forum: Sensors and Actuators
-
F
Buying a dimmable power supply
Thank you Sir for taking the time to reply my question.i really appreciate your Kind gesture.With the explaination you gave above,it means i can power the PCB with the power supply.Actually the only fear i had before has to do with blowing up the PCB as a result of over voltage.Unfortunately the...- firstoption
- Post #3
- Forum: Power Electronics
-
F
Buying a dimmable power supply
Good day to all, Please I Need your guide and support before buying this dimmable power supply: http://www.osram.com/osram_com/products/led-technology/indoor-ecg-for-led-modules-and-dimmers/compact-constant-current-dimmable/optotronic-intelligent/index.jsp I have a PCB that has a cluster of...- firstoption
- Thread
- Replies: 2
- Forum: Power Electronics
-
F
constant-current source for the control of 960 leds
Good day to all, Please i need your guide and support in the design of a Constant current source for the control of 960 Low power Leds Brightnes using PWM Signal.I have 8 pieces of PCB boards with each board having 120 Leds on it.The Leds are arranged in Parallel and Series.So each board has 24...- firstoption
- Thread
- Replies: 1
- Forum: LEDs and Optoelectronics
-
F
Supply current in relation to the total current consumed by a circuit
Sir thank you for the response to my question.i really appreciate your kind gesture.you really captured my mind.i actually thought the 5A will destroy the components on the board that was why I was looking for ways to adjust the output current.Yes,the components operate on 5V,they are all...- firstoption
- Post #3
- Forum: General Electronics Discussion
-
F
Supply current in relation to the total current consumed by a circuit
Good day to all, Please I need your support and guide on how to get the required current to my circuit.The power supply I intend to use has a switching regulator (RT8289GSP ) with output voltage of 5V/5A(based on the current configuration of the switching regulator-application note from...- firstoption
- Thread
- Replies: 3
- Forum: General Electronics Discussion
