-
Categories
-
Platforms
-
Content
Search results
-
T
Eagle: changing drill hole sizes
Hi, I am going through the process of producing my first PCB, including learning to use Eagle; my board is now routed ...but realise I need to change the hole sizes to match my drill bits: 1.0 mm 1.5 mm 2.0 mm 2.3 mm 3.0 mm 3.2 mm Otherwise it will get expensive if I need to buy a...- tuk
- Thread
- Replies: 0
- Forum: General Electronics Discussion
-
T
Oscilloscope? $110 budget
already have a decent volt meter but I'm thinking of buying a cheap Oscilloscope as part of learning about design/build small circuits, micro-controllers(arduino), RC filters, small amplifiers, relay drivers...that kind of thing. ..I can't see into the future or know enough atm to choose..so...- tuk
- Thread
- Replies: 10
- Forum: General Electronics Discussion
-
T
smooth range variable transformer?
not sure if this is in right section or even the right forum, I'l try to explain as best I can; I'm more software than hardware so bear with me :D parts: variac aka variable transformer ...adjusted using dial light bulb light detector what it does: if light being detected is above a...- tuk
- Thread
- Replies: 17
- Forum: General Electronics Discussion
