Voice Specifications

[Praveen Deshpande]

Hi All,

Recently I have got specifications for one project.
One of the input is "voice" for the module.
It is written for that;
INPUT:
* 1 no. of voice channel with 8KHz bandwidth(duplex)with 600/70-ohm
selectable
impedance.
* Electrical characterstics:600 ohms input impedance(transformer
coupled) 2-wire input provides 28 volt to power a telephone hand set.

OUTPUT:
* 2 wire output
* 600 ohm output impedance(transformer coupled)
* 28 volt output for powering a telephone instrument

There are few other inputs coming in to the module ,we have to MUX
them together
and send through multimode fiber link to other end.Similarly we need
to DEMUX them and route them to the appropriate lines.This all stuff
we are doing in a FPGA.
Actually I never worked on voice systems.Thus I am not able to
understand voice specs properly .
I suppose I may need to put a CODEC and SLIC.

Can anybody plz claify this specs for voice and
what way I may need to process this voice input to meet the given
specs.

Anticipating your cooperation.
Thanks in advance

Best regards

praveen

 

[Watson A.Name - Watt Sun, Dark Remover]

Hi All,

Recently I have got specifications for one project.
One of the input is "voice" for the module.
It is written for that;
INPUT:
* 1 no. of voice channel with 8KHz bandwidth(duplex)with 600/70-ohm
selectable
impedance.
* Electrical characterstics:600 ohms input impedance(transformer
coupled) 2-wire input provides 28 volt to power a telephone hand set.

OUTPUT:
* 2 wire output
* 600 ohm output impedance(transformer coupled)
* 28 volt output for powering a telephone instrument

There are few other inputs coming in to the module ,we have to MUX
them together
and send through multimode fiber link to other end.Similarly we need
to DEMUX them and route them to the appropriate lines.This all stuff
we are doing in a FPGA.
Actually I never worked on voice systems.Thus I am not able to
understand voice specs properly .
I suppose I may need to put a CODEC and SLIC.

Can anybody plz claify this specs for voice and
what way I may need to process this voice input to meet the given
specs.

Anticipating your cooperation.
Thanks in advance

Best regards

praveen

You may do better to ask this question on comp.dcom.telecom.tech
newsgroup.


--
@@F@r@o@m@@O@r@a@n@g@e@@C@o@u@n@t@y@,@@C@a@l@,@@w@h@e@r@e@@
###Got a Question about ELECTRONICS? Check HERE First:###
http://users.pandora.be/educypedia/electronics/databank.htm
My email address is whitelisted. *All* email sent to it
goes directly to the trash unless you add NOSPAM in the
Subject: line with other stuff. alondra101 <at> hotmail.com
Don't be ripped off by the big book dealers. Go to the URL
that will give you a choice and save you money(up to half).
http://www.everybookstore.com You'll be glad you did!
Just when you thought you had all this figured out, the gov't
changed it: http://physics.nist.gov/cuu/Units/binary.html
@@t@h@e@@a@f@f@l@u@e@n@t@@m@e@e@t@@t@h@e@@E@f@f@l@u@e@n@t@@