Maker Pro
Maker Pro

Very hard SMD identification.

  • Thread starter Lars Goldschlager
  • Start date
L

Lars Goldschlager

Jan 1, 1970
0
I don't hold a hope you'll be able to help me but here I go, I have a
small SMD device to identify, I am completely sure it's a transistor,
just not what type or values. It's part of a block of 3 transistors near
a comparator used in the power controlling board of a PSU, it's 3
terminaled, the type with a small black body and three leads, two in a
side, one lead in the opposite side (centered). The only markings I can
read in the burned shelling of the device is "1F".

hehehe very hard one. any luck? btw the device is phisically damaged, so
I doubt DMMing would help.
 
R

Ross Herbert

Jan 1, 1970
0
I don't hold a hope you'll be able to help me but here I go, I have a
small SMD device to identify, I am completely sure it's a transistor,
just not what type or values. It's part of a block of 3 transistors near
a comparator used in the power controlling board of a PSU, it's 3
terminaled, the type with a small black body and three leads, two in a
side, one lead in the opposite side (centered). The only markings I can
read in the burned shelling of the device is "1F".

hehehe very hard one. any luck? btw the device is phisically damaged, so
I doubt DMMing would help.


BC847B SOT23.
http://www.semiconductors.philips.com/acrobat_download/datasheets/BC847_BC547_SER_6.pdf
or
http://www.st.com/stonline/products/literature/ds/8839.pdf
 
Top