Scantronic 500r+ reset tamper

[MyKey]

Can any alarm gurus out there help a noob out. I've accidently
(stupidly) set off a tamper alarm by removing a detector from the
wall. How can I reset the detector etc? The user manual says contact
engineer for service, but I've no idea who installed the alarm. I have
a copy of the installation and user guide but need some help to find
the correct command. Do I need a special engineer code?

Thanks in advance
Mike

 

[GROUP MODERATOR]

Can any alarm gurus out there help a noob out. I've accidently
(stupidly) set off a tamper alarm by removing a detector from the
wall. How can I reset the detector etc? The user manual says contact
engineer for service, but I've no idea who installed the alarm. I have
a copy of the installation and user guide but need some help to find
the correct command. Do I need a special engineer code?

Thanks in advance
Mike

usually just put the cover back on and enter you code once or twice to
clear. or arm and disarm to clear depending on which system you have.

 

[Jim]

Can any alarm gurus out there help a noob out. I've accidently
(stupidly) set off a tamper alarm by removing a detector from the
wall. How can I reset the detector etc? The user manual says contact
engineer for service, but I've no idea who installed the alarm. I have
a copy of the installation and user guide but need some help to find
the correct command. Do I need a special engineer code?

Thanks in advance
Mike

I stupidly pulled a plug apart in the engine compartment of my car.
How can I reset the check engine light on the dash board. The manual
says to bring it to my mechanic, but I don't have a mechanic. I have a
copy of the users guide but need some help to find the correct
command. Do I need a special engineer code?

Duuuuuuuuuh Would it help to know what make model and year, my car is?
Duuuuuuu ...... HuH? HUH? Would it?

 

[GROUP MODERATOR]

unhook the battery for a few minutes then hook back up