herbey zepeda
- Aug 14, 2017
- 1
- Joined
- Aug 14, 2017
- Messages
- 1
Hello,
I'm looking at the following datasheet.
http://www.murata.com/~/media/webrenewal/products/sensor/infrared/ira/ira-s410st01-e.ashx?la=en
I am, naturally, interested in building a circuit that I can use to produce a signal (say 5 volts) if motion is detected.
In this datasheet, under "5-3 White Noise Level", there is a test circuit. Should I use this as a sample circuit to start using the motion sensor?
Thanks
I'm looking at the following datasheet.
http://www.murata.com/~/media/webrenewal/products/sensor/infrared/ira/ira-s410st01-e.ashx?la=en
I am, naturally, interested in building a circuit that I can use to produce a signal (say 5 volts) if motion is detected.
In this datasheet, under "5-3 White Noise Level", there is a test circuit. Should I use this as a sample circuit to start using the motion sensor?
Thanks
Last edited by a moderator: