Replaced laser, ....I don't get it.

[[email protected]]

Replaced laser pick up, error 11 ???? Pioneer DEH-2400

I don't get it. I pulled the working pick up out of this one to fix
another
deck (same model) Then, I ordered a new pick up and when it arrived
I installed it. Now, the disc spins, sled moves to center position and
laser makes 2 attempts to read, then displays error 11.

Pioneer DEH-2400
I need some feedback here.

yours truely,
tired and frustrated

 

[Sam Goldwasser]

Replaced laser pick up, error 11 ???? Pioneer DEH-2400

I don't get it. I pulled the working pick up out of this one to fix
another
deck (same model) Then, I ordered a new pick up and when it arrived
I installed it. Now, the disc spins, sled moves to center position and
laser makes 2 attempts to read, then displays error 11.

Pioneer DEH-2400
I need some feedback here.

Check for a solder blob or jumper that needs to be removed.

However, some/many/most? Pioneer pickups do not come adjusted when new.

--- sam | Sci.Electronics.Repair FAQ Mirror: http://repairfaq.ece.drexel.edu/
Repair | Main Table of Contents: http://repairfaq.ece.drexel.edu/REPAIR/
+Lasers | Sam's Laser FAQ: http://repairfaq.ece.drexel.edu/sam/lasersam.htm
| Mirror Sites: http://repairfaq.ece.drexel.edu/REPAIR/F_mirror.html

Note: These links are hopefully temporary until we can sort out the excessive
traffic on Repairfaq.org.

Important: Anything sent to the email address in the message header above is
ignored unless my full name is included in the subject line. Or, you can
contact me via the Feedback Form in the FAQs.

 

[Jerry G.]

Check to see if there is a shorting solder jumper or blob, to protect
the laser during shipping.

When installing, the calibration procedure must be done. You will need
the calibration CD, DVM, and a scope to properly do the job. Refere to
the service manual for details.

Jerry G.
======

 

[Jerry G.]

Check to see if there is a shorting solder jumper or blob, to protect
the laser during shipping.

When installing, the calibration procedure must be done. You will need
the calibration CD, DVM, and a scope to properly do the job. Refere to
the service manual for details.

Jerry G.
======