Maker Pro
Maker Pro

OT, but only just. Looking for an oven

L

L.A.T.

Jan 1, 1970
0
I have to replace a stove/oven combination that is difficult to find.
Perhaps someone here can help.
It is standard width, one-piece, and is permanently attached to, and sits
on, the kitchen bench. The oven is above the cooktop, at about eye-level.
The existing unit is gas, but an electric replacement would be as good, or
possibly better. I have tried to navigate a couple of manufacturer's sites,
with little success. It is a bit hard to describe this unit to any of the
pop-up pop-down menus provided by Simpson, or F&P and so on. Has anyone
seen such a unit? The existing one is probably more than twenty years old.
 
A

aussiblu

Jan 1, 1970
0
What brand and model is the existing one?
 
L

L.A.T.

Jan 1, 1970
0
aussiblu said:
What brand and model is the existing one?
Thanks for your reply.
I can't see what the make or model is. I can't even remember when it was
bought. It was more than twenty years ago, from the Gas and Fuel Corp, in
Melbourne. Gas and Fuel was wound up in 1995, I think. My problem is that
there is nowhere in the kitchen where a normal sort of oven/stove would fit
without a lot of carpentry.
 
Top