poor mystic
- Apr 8, 2011
- 1,074
- Joined
- Apr 8, 2011
- Messages
- 1,074
Hi, Everybody and Robotics People in particular
Surely you could use a 2-dimensional positioning table, with a cutting head, to cut away copper on an unetched board and make a pcb.
I wonder why nobody does this?
You'd get a speedy result and good definition at a low price.
Surely you could use a 2-dimensional positioning table, with a cutting head, to cut away copper on an unetched board and make a pcb.
I wonder why nobody does this?
You'd get a speedy result and good definition at a low price.