Not a great week. Yesterday I blew up two anglegrinders in a row and today I fried my welder. The wirefeeder is dead. The torch is fine, it reads 20.8 volts but when I measure the motor that controlls the wire feeder there's no voltage at all. I made a couple of pictures with some clarification here and there. Is there anyone that knows a thing or 2 about electrics or welders? It's a Bimax 123
This is the front of the welder
Rear of the welder
Better look of the pcb at the front of the welder
This is the front of the welder
Rear of the welder
Better look of the pcb at the front of the welder