-
Categories
-
Platforms
-
Content
Search results
-
D
engine time controlled actuator
yeah, im looking for the actual control system i would need, i've already got the hall system figured out- dieseltekkie
- Post #9
- Forum: Sensors and Actuators
-
D
AVR for 3phase generator
ok well then that makes me feel better- dieseltekkie
- Post #7
- Forum: General Electronics Discussion
-
D
engine time controlled actuator
hmmm that might be very helpful- dieseltekkie
- Post #7
- Forum: Sensors and Actuators
-
D
engine time controlled actuator
I was thinking of running a tone wheel with 23 teeth (the 24th tooth missing to denote #1 cyl at tdc) then there would be a 7.5deg gap between the teeth if the teeth were to encompass 50% of the time. therefore cyl #1 would close the circuit on the gap immediately following tooth #23 and then...- dieseltekkie
- Post #5
- Forum: Sensors and Actuators
-
D
AVR for 3phase generator
this is what happens when nobody is in direct contact when a generator fails http://www.iaei.org/magazine/2010/05/grounding-of-wind-power-systems-and-wind-power-generators/- dieseltekkie
- Post #3
- Forum: General Electronics Discussion
-
D
engine time controlled actuator
yeah i was thinking of a hall system but a way of having 1 hall sensor with a toothed wheel would be much better and run it similar to a modern car ignition system so that you don't have a group of magnets on the harsh environment of the front of an engine crankshaft or in the confined space of...- dieseltekkie
- Post #3
- Forum: Sensors and Actuators
-
D
engine time controlled actuator
I'm trying to design a part for an engine that will control the exhaust valves on an engine much like that of a semi truck engine brake but I'm running into a bit of an issue with figuring out how to make the timing module. I need a trigger wheel, pickup sensor, and the stuff that will make it...- dieseltekkie
- Thread
- Replies: 8
- Forum: Sensors and Actuators
