Maker Pro
Maker Pro

WTB: 0.1uF capacitor 1% tolerance for timing cricuit repair

  • Thread starter David C. Partridge
  • Start date
D

David C. Partridge

Jan 1, 1970
0
Anyone in UK got any *axial* lead 1% tolerance 0.1uF caps they can spare one
of - I'll pay reasonable cost + postage.

Working voltage of original is 100V, but anything over 50V should be fine.
 
I

Isaac Wingfield

Jan 1, 1970
0
David C. Partridge said:
Anyone in UK got any *axial* lead 1% tolerance 0.1uF caps they can spare one
of - I'll pay reasonable cost + postage.

Working voltage of original is 100V, but anything over 50V should be fine.

Might save a lot of time if you'd build it up out of smaller units,
using the capacitance measuring function of your DVM.

Isaac
 
D

David C. Partridge

Jan 1, 1970
0
Not a viable option in this case (physical space constraints), and in any
case I don't trust a DMM to be accurate enough on capacitance. It really
does need to be 1% as there's no room to fit a pot to replace the R part
(also 1%) of the R/C timing circuit.

Dave
 
Top