Maker Pro
Maker Pro

SEW IPOS mc41

  • Thread starter Keicon Automatisering
  • Start date
K

Keicon Automatisering

Jan 1, 1970
0
I'm looking for sample source code, with simple hw input, output stuff and
profibus dp, of a SEW IPOS MC41.
I have to make an program that turns 360 degrees and should read in one
input. After it should turn to the middle of the pos and neg edge of the
signal. Not very difficult but I've never programmed in movitools 3.0.

I would be very happy with a sample with one input, and all the commands to
turn, read the angle and send one signal to a plc at the dp network.

Regards,

Keimpe
 
Top