I am working as part of a group to make a locked container that when an alarm is sounded form the pre-set timer, a servo will activate removing the looking pin on the device. This will require 2 servos as there will be 2 locks. I also need to include a reset button to reset the servos so the locks are activated again to be 'opened' when the next alarm is set.
I am in a complete panic and really freaking out, I am the only person in my group with 'electronics' background but in reality i haven't done much in the ways or electronics at all.
Components I was on looking to include are as follows:
Arduino uno
Real-time clock circuit
LED's (to be activated along with Buzzer)
Buzzer
2x servo motors requiring to be moved roughly 90 degrees
I am in a complete panic and really freaking out, I am the only person in my group with 'electronics' background but in reality i haven't done much in the ways or electronics at all.
Components I was on looking to include are as follows:
Arduino uno
Real-time clock circuit
LED's (to be activated along with Buzzer)
Buzzer
2x servo motors requiring to be moved roughly 90 degrees
Last edited by a moderator:
