M
microlatina
- Jan 1, 1970
- 0
Hello ! I am a new member and please forgive my inexperience. I would
like to autoroute just a selected area in my PCB, but I don't get the
result I expect. When I select the area, the program autoroutes all
the connections that start at this selected area and continues to
autoroute the complete board. I tried to set a Keep Out region as
large as the border of my board. Also I tried to remove this Keep Out
and draw it just arround this selected region but I get no results.
Which would be the correct way to do this ? Is this possible ? I
really can't find the information in the manual.
Thank you very much in advance.
Robert
like to autoroute just a selected area in my PCB, but I don't get the
result I expect. When I select the area, the program autoroutes all
the connections that start at this selected area and continues to
autoroute the complete board. I tried to set a Keep Out region as
large as the border of my board. Also I tried to remove this Keep Out
and draw it just arround this selected region but I get no results.
Which would be the correct way to do this ? Is this possible ? I
really can't find the information in the manual.
Thank you very much in advance.
Robert
