Maker Pro
Maker Pro

Lighted steps, switched/timer for 110 volt

S

shawn

Jan 1, 1970
0
I installed rope lighting down my steps and put security mats under the
bottom and top steps. Since allot of my home is X10 I tried an MS13a
Motion detector, I was half way down my steps before they came on!! lol
So I thought I'd try an X10 PRO Powerflash Burglar Alarm Interface
PSC01, Again half way down the steps! Well now I'm looking for a
circuit strictly for this. The security mats just close a loop so if
anyone has seen this type of circuit, or circuit board please let me
know! My knowledge level is just an old time electronic geek that can't
remember the calculations to create his own circuit! But I can solder
one if I had a parts list and schematic! I would like the timer set
between 20 sec and 1or2 min!
Thanks!
Shawn
 
E

ehsjr

Jan 1, 1970
0
shawn said:
I installed rope lighting down my steps and put security mats under the
bottom and top steps. Since allot of my home is X10 I tried an MS13a
Motion detector, I was half way down my steps before they came on!! lol
So I thought I'd try an X10 PRO Powerflash Burglar Alarm Interface
PSC01, Again half way down the steps! Well now I'm looking for a
circuit strictly for this. The security mats just close a loop so if
anyone has seen this type of circuit, or circuit board please let me
know! My knowledge level is just an old time electronic geek that can't
remember the calculations to create his own circuit! But I can solder
one if I had a parts list and schematic! I would like the timer set
between 20 sec and 1or2 min!
Thanks!
Shawn
You can make a timer simply. Go here:
http://www.doctronics.co.uk/555.htm

Scroll down to monostable.

You really ought to fix the sensor(s). 1/2 way down
the stairs before it "knows" you're there is unacceptable
performance.

Ed
 
Top