Forbes Kershaw
- Jun 8, 2016
- 1
- Joined
- Jun 8, 2016
- Messages
- 1
Hi, first post,
Have a problem trying to get information on some components on a lexium board.
The problem is 240v was connected to the 24v enable input ( PSU was marked incorrectly )
And now the drive will not enable, the drive will enable and run the motor thought the software though ,
But will not enable externally, we think we have traced the fault to a couple of resistors and the optocoupler the problem is we have done a search and can not get any info on the components.
Any help would be very much appreciated.
Have a problem trying to get information on some components on a lexium board.
The problem is 240v was connected to the 24v enable input ( PSU was marked incorrectly )
And now the drive will not enable, the drive will enable and run the motor thought the software though ,
But will not enable externally, we think we have traced the fault to a couple of resistors and the optocoupler the problem is we have done a search and can not get any info on the components.
Any help would be very much appreciated.