Maker Pro
Maker Pro

I've been trying to put a paper design on a bread board and not getting through

Nwanno Promise

Nov 23, 2016
1
Joined
Nov 23, 2016
Messages
1
I've been trying to put a paper design on a bread board and not getting through. Precisely, I want to create an amplifying system with a mosfet transistor I already have (50N06), looked up for details of the transistor online. Basically, my problem is that I was expecting to find approximately zero voltage across the gate resistor (Rg) but it appears to be taking away all my D.C Volatage and leaving the drain resistor (Rd) with none- I'm using the drain feedback method of bias. please the smallest possible help and suggestion is appreciated
 

davenn

Moderator
Sep 5, 2009
14,251
Joined
Sep 5, 2009
Messages
14,251
welcome :)


so show us your circuit diagram
 

(*steve*)

¡sǝpodᴉʇuɐ ǝɥʇ ɹɐǝɥd
Moderator
Jan 21, 2010
25,510
Joined
Jan 21, 2010
Messages
25,510
And, if possible, a photo of your breadboard so we can see what you've done.
 
Top