G
Graham Hill
- Jan 1, 1970
- 0
I have a Tek 2710 Spectrum Analyzer that has several faults, its main
error message is
"cannot count (VCO,IF)"
I have the manual but it is virtually useless on interpreting the
firmware diagnostics routines, does anyone know this message, there
are at least 3 VCOs and 3 IFs, worst case scenario is probably a bad
YIG but the diagnostics should be able to narrow the possibilities a
bit more for me
Graham (remove the ham from my address)
error message is
"cannot count (VCO,IF)"
I have the manual but it is virtually useless on interpreting the
firmware diagnostics routines, does anyone know this message, there
are at least 3 VCOs and 3 IFs, worst case scenario is probably a bad
YIG but the diagnostics should be able to narrow the possibilities a
bit more for me
Graham (remove the ham from my address)
