Hi, I'm kind of a newbie on this stuff and well basically I was following a tutorial on youtube on how to control a DC Motor with Labview VI, this is the VI to be used with this project http://www.mediafire.com/file/p96ey18wikixyil/pwm.zip and I will leave the diagram at the bottom of the post.
I wanted to know if there is anyway that I could place 1 or 2 leds somewhere in the breadboard so when the motor starts the leds lighten up and turn off when the motor is not on. I tried placing the leds with their respective polarity to the + and - of the motor but still no luck, would I need resistors? and how can I place the components in order to get it to work?
Thank you very much in advance.
I wanted to know if there is anyway that I could place 1 or 2 leds somewhere in the breadboard so when the motor starts the leds lighten up and turn off when the motor is not on. I tried placing the leds with their respective polarity to the + and - of the motor but still no luck, would I need resistors? and how can I place the components in order to get it to work?
Thank you very much in advance.