Maker Pro
Maker Pro

how to increase 6vdc to 12vdc

R

randomname

Jan 1, 1970
0
hey everyone.. i have 4 AA batteries and need to sqeeze 12v out of
them. can this be done?

-sam
 
C

Chris

Jan 1, 1970
0
randomname said:
hey everyone.. i have 4 AA batteries and need to sqeeze 12v out of
them. can this be done?

-sam

Hi, Sam. The easiest way to do it is with a 555/voltage doubler.
Here's a link:

http://www.reconnsworld.com/power_voltdoubler.html

The output voltage is slightly less than 2X the input voltage, and it's
not regulated. That means the output voltage will drop if you need
more current.

The circuit shown is good for about 25mA with no more than a volt of
ripple.

If this doesn't do the job, please post again.

Cheers
Chris
 
E

Eeyore

Jan 1, 1970
0
randomname said:
hey everyone.. i have 4 AA batteries and need to sqeeze 12v out of
them. can this be done?

There are various methods, all of which involve active electronics.

To suggest the best answer one would need to know more info like load current
and ripple / regulation.

Graham
 
H

Homer J Simpson

Jan 1, 1970
0
There are various methods, all of which involve active electronics.

Or a synchronous vibrator! You could probably make one with reed relays.
 
J

jasen

Jan 1, 1970
0
hey everyone.. i have 4 AA batteries and need to sqeeze 12v out of
them. can this be done?

12000V from 6 isn't a huge problem 12V from 6 is much easier.
have any idea of how much current or power you need (how many
amps or how many watts)

Bye.
Jasen
 
R

Roger Dewhurst

Jan 1, 1970
0
jasen said:
12000V from 6 isn't a huge problem 12V from 6 is much easier.
have any idea of how much current or power you need (how many
amps or how many watts)

Can a voltage multiplier be run off unpulsed DC?

R
 
Top