Maker Pro
Maker Pro

Harman kardon hk395 help

Status
Not open for further replies.

Mr.fix it_101

Apr 11, 2015
30
Joined
Apr 11, 2015
Messages
30
Hello everyone. I need your help once again.
My friend has a harmon kardon subwoofer that he has trouble connecting the wires from a dual pot(which controls the subwoofer volume) to the main board. Apparently it was previously damaged, knocking out the left/right control knob for the sub.
Can you assist him by telling to which pins on the circuit board does he connect the wires leading from the potentiometer (subwoofer volume control).
in the picture provided, the pins are highlighted with a RED arrow pointing at them.

Thank you all in advance as your help will be appreciated
 

Attachments

  • subby.jpg
    subby.jpg
    31.2 KB · Views: 244
  • subvolume.jpg
    subvolume.jpg
    21 KB · Views: 242
  • dual10kpot.Jpg
    dual10kpot.Jpg
    31.8 KB · Views: 222

73's de Edd

Aug 21, 2015
3,613
Joined
Aug 21, 2015
Messages
3,613
Sir Mr.fix it_101 . . . .

There is a WHOLE lot that you are not showing or telling about that connector.
As it is supposed to connect to a plug and ribbon connector as is dshown in the YELLOW area and then the ribbon cable routes up the RED dot path of the second pic . . .WHERE . . . there is a minor PCB which has a control -mini jack- and Philips 9.1 mini Din connector which connects to Satellite speakers coming into the unit.
That PCB is the part that is needed to be seen as well as a photo of the front panel of the unit as well as that Mini din and its surrounding area.
SAMSUNG was the originating Sugar Daddy of this unit with it also REMARKED as both DELL and CARMEN HARD-ON.

REFERENCE
Supp_HK395.png



73's de Edd
 
Last edited by a moderator:

Mr.fix it_101

Apr 11, 2015
30
Joined
Apr 11, 2015
Messages
30
Sir Mr.fix it_101 . . . .

There is a WHOLE lot that you are not showing or telling about that connector.
As it is supposed to connect to a plug and ribbon connector as is dshown in the YELLOW area and then the ribbon cable routes up the RED dot path of the second pic . . .WHERE . . . there is a minor PCB which has a control -mini jack- and Philips 9.1 mini Din connector which connects to Satellite speakers coming into the unit.
That PCB is the part that is needed to be seen as well as a photo of the front panel of the unit as well as that Mini din and its surrounding area.
SAMSUNG was the originating Sugar Daddy of this unit with it also REMARKED as both DELL and CARMEN HARD-ON.

REFERENCE
Supp_HK395.png



73's de Edd
As I mentioned before, the unit was previously damaged. so there are no left/right knob as would have been originally, nor does a ribbon cable runs to a secondary PCB at the volume control. all the unit has is a POT(used for volume control for the sub) and two wires leading from the POT towards the main PCB. No ribbon cables, NO PCB for sub knobs
 
Last edited by a moderator:
Status
Not open for further replies.
Top