Error d1 on Ademco 6128...

[Patrick Lewis]

I recently installed a 4110xm with a Ademco 6128 keypad. After powering up I
received a d1 error on the keypad. According to the manual this may occur
during power up but goes away. I've reset the power, still no luck.

Any ideas on what this message indicates?

 

[Jim Rojas]

Sometimes it takes a minute or 2 for the d1 to go away. Let it go for 5-10
minutes. When you return, and it still displays d1, you have a bad panel.

Jim Rojas

 

[Sharmon]

Go in then exit program mode then Arm and disarm the system

 

[phil]

Upon power-up,if it shows dI,it is indicating the panel is temporarily
disabled.To exit this mode,key in # and 0.