Maker Pro
Maker Pro

ECG front end simulation

bmibitmesra

Nov 29, 2016
2
Joined
Nov 29, 2016
Messages
2
Hello.
I want to simulate the ecg front end circuit but I dont know how am I gonna feed in the input so that i can get an ecg at the output stage. I found this circuit here on this forum and i am interested in developing it for my forthcoming mini project. The circuit is attached. If I can simulate it using NI MultiSIM ? Also while I was trying to build the same in MultiSIM I was unable to find MCP6002 IC.
If you guys can help me it would be a big support.
 

Attachments

  • Circuit 50 hz.jpg
    Circuit 50 hz.jpg
    59.2 KB · Views: 81

Audioguru

Sep 24, 2016
3,656
Joined
Sep 24, 2016
Messages
3,656
The circuit you posted will produce a lot of 50Hz mains hum and other interference on its output because the patient and the wires to the probes pick it up. Most ECG circuits cancel the interference by feeding out-of-phase AC and DC interference signals to the patient's right leg.
 

Attachments

  • ECG-3.PNG
    ECG-3.PNG
    22.8 KB · Views: 327

bmibitmesra

Nov 29, 2016
2
Joined
Nov 29, 2016
Messages
2
the quad amp MCP6004 is not available in multisim library. please assist me how can i add it.
 

Alec_t

Jul 7, 2015
3,587
Joined
Jul 7, 2015
Messages
3,587
Since this is simulation rather than real life you can use any comparable amp model.
 
Top