Maker Pro
Maker Pro

Crosspost: Advise and datasheets needed

I

Ivan

Jan 1, 1970
0
First of all, i'm sorry because of crossposting. I didn't know on wich
groups to post this question so sorry. Second sorry on bad english.

Hi everyone.. i bought few steppers so i need datasheets or more information
for them. Thanks

#1
5 phase stepping motor
A3851-9215
DC 1.3 A 1.4 ohms/phase
0.72 deg / step
FH7-1804
vexta, oriental motors
5 wires - black, green, yellow (orange?), red, blue..
Is this motor compatible for any CNC use?

#2
Type KH56Jm2U014
no 3408
japan servo co., ltd
6 wires, black, red, brown, yellow, blue, orange..
Is this motor compatible for any CNC use?

#3
Vexta
model C6957-9015K,
5 phase, 0.72 deg/step
DC 1.5A, 0.73 ohm,
VS7 69368,
oriental motors
5 wires - black, green, yellow (orange?), red, blue..
Is this motor compatible for any CNC use?

#4
Minebea,
p/n EM-181
type 17PM-H005-P2V
6 pins on connector..

Can i use these motors in combination with this driver and PC PSU for 12V
input? http://cratel.wichita.edu/blogs/tommcguire/the-stepper-motor-driver/

Thanks again!!
 
Top