Maker Pro
Maker Pro

advice for making a tiny device for data collection and transmission

Hello,

Im using some hobby time to make a device which collects data from a
remote temperature sensor and then performs some rudimentary
corelation analysis and stores it on board (about 8-16MB) for
sometime. Later it will be transmitted using a class 3 Bluetooth
transmitter to my PDA.

The above is the conceptualization.
Ive searched around and found devices from microchip(http://
www.microchip.com) for the PIC processing chip, But the chips offered
are slightly bigger than what im aiming for. Im clueless as to the
best components out there. Im looking at each to have a really small
form factor (of lesser than 5x8mm^2), for each of the components
above.

Any suggestions reg the optimal microprocessor/pic chip ; Btooth,
storage would be welcome. Also a bluetooth transmitter which also
comes with signal processing inbuilt would may possibly help to cut
down the size(?)

thanks

ss
 
Top