Maker Pro
Maker Pro

40 pin lcd to 50 pin controller board

Kody

Feb 17, 2017
2
Joined
Feb 17, 2017
Messages
2
so I am doing this project where I'm making my own monitor for things that use HDMI and vga and all that. The monitor I got for it has a 40 pin connector and the controller board has a 50 pin connector in it. I don't really have a lot of time or money for this project so I was wondering if I can just solder the wires on the board and the monitor together but I'm not sure what pins Controll power or signal or anything. My LCD screen is off a hp pro book 4545s and my controller board I bought from this link https://www.amazon.com/HDMI-Controller-Board-1280x800-panel/dp/B01MS13A5W . I would really appreciate it if I could get some help asap. Thank-you.
 

(*steve*)

¡sǝpodᴉʇuɐ ǝɥʇ ɹɐǝɥd
Moderator
Jan 21, 2010
25,510
Joined
Jan 21, 2010
Messages
25,510
Are you certain that the display and the controller are compatible?

Do you have the datasheets for both?
 

Kody

Feb 17, 2017
2
Joined
Feb 17, 2017
Messages
2
Are you certain that the display and the controller are compatible?

Do you have the datasheets for both?
I don't have the data sheets but I was told that I can solder the wires together if I can figure out what pin is for what. But I can't find any info on the pins
 
Top