Maker Pro
Maker Pro

zigbee module

enrakeshkumar

Feb 15, 2016
3
Joined
Feb 15, 2016
Messages
3
I have a zigbee module cc2500(onlysupport.co.in).
It has a facility to measure rssi value
But i dont know how to use it.
Please help me to measure rssi value of the received signal
I need to use rssi as a reference value and i am going to use arduino uno.

Thank u
 

Attachments

  • cc2500_rs232_rssi_txrx_front.jpg
    cc2500_rs232_rssi_txrx_front.jpg
    71.5 KB · Views: 67
Last edited:

Amol Shah

Feb 24, 2016
1
Joined
Feb 24, 2016
Messages
1
I don't think anyone other than the onlysupport guys can help as it looks a customised product designed by them along with their own microcontroller. I hope the only support guys can provide support :p
 

hevans1944

Hop - AC8NS
Jun 21, 2012
4,878
Joined
Jun 21, 2012
Messages
4,878
Lots more information is available on this page. Download the DATASHEETS referenced near the bottom of the page and read them. Do your own homework! Reading the RSSI value requires access to control registers in the RFM75 data modem via its 4-pin SPI data link. The documentation may tell you whether or not the RFM75 registers can be accessed from the serial RS-232 communications port via the on-board Atmel μP. In other words, does the Atmel programming allow control of the RFM75 from the RS-232 port? Please read all the available documentation before posting more questions here.
 

Harald Kapp

Moderator
Moderator
Nov 17, 2011
13,700
Joined
Nov 17, 2011
Messages
13,700
@enrakeshkumar : This is your 3rd thread on this topic. I already closed one other and I will close this one, too, as it the older of the two remaining threads.
I kindly ask you not to open a new thread when there is already an open thread on the same topic.
 
Top