Connect with us

Zero Ohm resistor temination

Discussion in 'Misc Electronics' started by [email protected], Jan 26, 2005.

Scroll to continue with content
  1. Guest

    Hi,
    What is the fundamental behind 'zero Ohm resister termination'? What
    value is this 0 Ohm resister is going to add on signal integrity?
    Thanks in advance.

    Regards,
    Muthu.
     
  2. Jim Thompson

    Jim Thompson Guest

    It will make it very quiet ;-)

    ...Jim Thompson
     
  3. Jamie

    Jamie Guest

    used as fuse links, used as jumpers on boards and depending
    on what type they are , some times used as local RF stand off
    chokes with a by pass cap on the other side.
    etc..
    i have also seen them used in double side boards where there
    is a coil foil pattern on one side and the 0 ohm R on the other
    lined up on top of each other, this is like a parasitic choke
    mostly found were R.F. traveling around was a concern.
     
  4. Jerry G.

    Jerry G. Guest

    Zero "0" ohms means that there is no resistance. In theory, it means total
    conductance. In practice, it can be a piece of wire.

    A zero ohm termination, really means a short, to terminate the load.

    --

    Jerry G.
    =====

    Hi,
    What is the fundamental behind 'zero Ohm resister termination'? What
    value is this 0 Ohm resister is going to add on signal integrity?
    Thanks in advance.

    Regards,
    Muthu.
     
  5. Ross Mac

    Ross Mac Guest

    I have seen them as circuit board jumpers on rigid circuit boards and also
    mistaken pico fuses too.....Ross
     
  6. Guest

    Thanks all for your knowledge sharing...
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-