Connect with us

Zenith 35" T.V.!!

Discussion in 'Electronic Repair' started by Rono, Jun 1, 2005.

Scroll to continue with content
  1. Rono

    Rono Guest

    M # Z35X21D, rebuilt PWM power supply:
    Replaced CX3416 100uf, CX 3413 22uf,
    CX3424 2200 uf, both regulators, unit works
    fine in every way, but regulator heatsink get very
    hot. Touch it for 3-4 seconds...ouch. But the unit
    runs all day, just afraid it will overheat & "blow"
    again. Did I miss anything to cause overheating?
    Horizontal output is cool enough. Rono.
     
  2. Art

    Art Guest

    Check the load circuits for those specific regulators, may have something
    causing increase current demand.
     
  3. Guest

    If it's not already home, send it home. They do run very hot.
    That's why this repair is rather common.

    David, on the Illinois prairie.
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-