Connect with us

zebra strip to metal lead lcd

Discussion in 'LEDs and Optoelectronics' started by edaurdot1406, Dec 28, 2020.

Scroll to continue with content
  1. edaurdot1406

    edaurdot1406

    2
    0
    Dec 28, 2020
    I have a device that has an lcd. The lcd used a zebra strip to connect to the PCB, but the zebra strip is broke . I have a lcd that is the same as my zebra strip but uses a metal lead connection. Is there a way to connect the metal lead to the same spot as the zebra strip was and how would I do this
     
  2. Bluejets

    Bluejets

    4,991
    1,048
    Oct 5, 2014
    Connect to pc board pins underneath perhaps...???

    How did you determine the replacement is the same as the original..??
     
  3. edaurdot1406

    edaurdot1406

    2
    0
    Dec 28, 2020
    How would I figure out which pin connects to where.

    they have the same amount of pins and the same display.
     
  4. davenn

    davenn Moderator

    13,866
    1,958
    Sep 5, 2009
    which means nothing :)

    you would need to get the datasheet for each display and compare the pin-outs

    they may be the same, they may be totally different
     
  5. Martaine2005

    Martaine2005

    3,555
    966
    May 12, 2015
    Why not replace the strip?.
    Here you can read all about them. Ebay has quite a few. Just check the length height and PCB pin spacing.

    Martin
     
    Harald Kapp and davenn like this.
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-