Connect with us

Yusynth metaliser

Discussion in 'Audio' started by darren adcock, May 6, 2018.

Scroll to continue with content
  1. (*steve*)

    (*steve*) ¡sǝpodᴉʇuɐ ǝɥʇ ɹɐǝɥd Moderator

    25,361
    2,756
    Jan 21, 2010
    I was going to add, before you posted this, that you just try the 15V unit out.

    As we noted, there's not much that actually needs changing. And do those things which appear to need to be changed, may not... :)
     
  2. darren adcock

    darren adcock

    463
    34
    Sep 26, 2016
    Thanks again Steve. One would hope such a huge clanger can only happen once, doh!

    I will try the unit on it's own tomorrow and compare the difference.
     
  3. darren adcock

    darren adcock

    463
    34
    Sep 26, 2016
    Hey Steve, tried the module out running at +/- 15v today comparing it with +/- 12v and I could hear no discernible difference so I guess I jut leave it and move onto the next module. I have vclfo which i suspect needs adjusting to enable the low frequencies. But will look at this tomorrow and shout back to check i'm going in the right direction. Wish I'd checked in more with this synth build as I went through it to save time and confusion, but then I guess making mistakes and correcting them is teaching me a lot., if I'd gone with the complete kit build version I doubt I would have learned as much. Thanks again.
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads
There are no similar threads yet.
Loading...
Electronics Point Logo
Continue to site
Quote of the day

-