Hemant Choudhary
- Nov 1, 2016
- 49
- Joined
- Nov 1, 2016
- Messages
- 49
Hi All and Sir 73's de Edd,
With all confidence i was sure, upon isolating few components, as mentioned above, the +3.3DSP and +1.3 supply line to the DSP chip was shorted and also the DGND.
i tried to remove the DSP with the hot air gun but even after heating to a good amount of time the IC was not ready to move off its pad.
then i was afraid that after a prolonged expose to the hot air may be i should check the digital board with its entire connection, then ALAS, its gone.
Now, no relay click nothing. i think its DEAD ( This time in real sense).
Here i would like to thank you sir, for your help and the knowledge that you have put forward to me taking all the pains of drawing the diagram, especially for me. i truly appreciate and look forward to you for my new project, which is arriving fast.
Once again thanks a lot to this entire forum community.
Regards,
Hemant.
With all confidence i was sure, upon isolating few components, as mentioned above, the +3.3DSP and +1.3 supply line to the DSP chip was shorted and also the DGND.
i tried to remove the DSP with the hot air gun but even after heating to a good amount of time the IC was not ready to move off its pad.
then i was afraid that after a prolonged expose to the hot air may be i should check the digital board with its entire connection, then ALAS, its gone.
Now, no relay click nothing. i think its DEAD ( This time in real sense).
Here i would like to thank you sir, for your help and the knowledge that you have put forward to me taking all the pains of drawing the diagram, especially for me. i truly appreciate and look forward to you for my new project, which is arriving fast.
Once again thanks a lot to this entire forum community.
Regards,
Hemant.