Connect with us

XESS board XSV-300, help

Discussion in 'Electronic Basics' started by a g, Dec 8, 2004.

Scroll to continue with content
  1. a g

    a g Guest

    Hi,

    I have an XSV-300 board with me. I am using gxsload to upload the contents
    of the ram on to my pc. Could any one tell me how the tool accesses the ram
    banks (sequence)? My design fetches udp packets over ethernet and stores the
    data into the ram. For testing, I send packets with ascii data in them. When
    I tried sending 0s, the uploaded ram contents in the hex file were a series
    of 3032s. Now the 30s, that's the ascii for what i'm storing. But I can't
    figure out where the 32s are coming from. My initial guess was I'm writing
    in right banks and may be left banks had 32s. But I tried writing to left
    banks and had the same result. I tried changing the number that I send but
    every time the number is followed by a 32.
    Any help on this would be greatly appreciated.

    Thanks.
    -Arun
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-